|
|
The Problem - Pressure Measurement in Engine Test Cells Does synthetic oil reduce bearing wear? Do gasoline additives really improve combustion? These questions are investigated in a special laboratory known as an engine test cell. There are many pressure measurements needed on an engine: oil pressure, exhaust pressure, coolant pressures and any number of emission pressure measurements. Pressure transducers must be protected from the ambient environment of the test cell and still provide useful signals to a data acquisition system. An engine test cell is a noisy, dirty and cramped room containing a running engine and everything needed to conduct the test and make the required measurements. The engine must have a sturdy mounting and a dynamometer to simulate loads. There must be piping to remove the exhaust gases and to bring in clean air. There must be adequate ventilation so that heat exchanged by the radiator can be removed from the test cell.
The Solution Pressure transducers used inside the engine test cell are mounted in a large protective enclosure that usually hangs from the wall or the ceiling. There are often several dozen transducers inside the enclosure and all of the power and signal wiring must be brought out to the data acquisition system outside the test cell. The plumbing for the transducers is a series of hoses that are connected to the outside of the enclosure and run to various points on the engine. Because the enclosure holding the transducers is tightly packed, the ideal transducer must be compact and easy to install. The cramped conditions in the typical test cell also require that the transducer be highly reliable; changing out a pressure transducer during a long-term engine test will inevitably create gaps in the test data. A high-level output from the transducer reduces cost for external signal conditioning for the data acquisition system.
Validyne Products The Validyne P55 is a compact, rugged transducer that has been used in a wide variety of engine test cell applications. The P55 mounts to any flat surface with just 4 bolts. The 1/8” NPT female pressure connections are oriented such that a wide variety of adapters can be fitted to streamline the plumbing. The P55 also provides a +/-5 Vdc signal that can be fed directly into a data acquisition system.
|
|
|||||||||
| Phone: 818.886.2057 || Email: Sales@validyne.com |
|
